Miếng dán sợi carbon dùng để bảo vệ và trang trí ngưỡng cửa/cản trước và cản sau xe hơi TZ-001

Giới thiệu Miếng dán sợi carbon dùng để bảo vệ và trang trí ngưỡng cửa/cản trước và cản sau xe hơi TZ-001

【DIY BUMPER GUARD】
️ Annoying Scratches???Collision of Paint?? Carbon Fiber Bumper may Be your Best Choice for Protection and Decoration,Oneself Begin Affixed, Can Prevent Tread Mark already Very Beautiful, Anti Collision.

【Installation location】
️ This Carbon Fiber Rubber can be installed door sill position,Door side, Rear tail box,Tail box cover,Front and rear bumpers,Rear view mirror and Other locations.Suitable for car pickups or SUV.
️ Make your car more beautiful with Bright carbon fiber of decoration and anti-collision.

【Materials】
️ High-quality Carbon fiber rubbe materials.Cover existing scratches and prevents your car from wear and tear, scratches paint scratches.
️ Also it can be used to cover any existing scratches, paint damage.Decorative and protective your lovely car.

【GOOD COMPATIBILITY 】
️ Door Bumper Protective strip can be Free deformation and Free clipping. High Suppleness and Durable:made of rubber,wearproof, can be bent,last along service life.

【Easy to install】
️ first, clean the surface mounting position, the adhesion promoter is rubbed in the adhesive position, then peel off the strong 3M tape protective film and paste it.

【BEAUTIFUL and FASHION】
️ Black Carbon Fiber Texture, Front and Rear bumper guard anti-collision protective.
️ Door Sill Scuff Pedal Protector. Rear Bumper Trunk Paint Protection.

【specification】
️ Material: carbon fiber
️ Color: black, red, blue
️ Size: 5x100CM.

【notes】
️ We provide clear pictures and measurements whenever possible.
️ Due to the difference in display, the actual project color may be slightly different from the list image.
️ Manual measurement may be slightly wrong, please make sure you don’t mind before buying

How to Keep the Adhesive Steady and tough?
️ Pay attention to the position that needs to be pasted. It must be cleaned the dust or oil on the windshield. You can use alcohol or clean water to polish the position where it needs to be adhered. After the surface is dry, stick it.
️ When pasting, do not touch the adhesive rubber surface with your hands. The adhesive tape will be greatly weakened due to the oil stain or fingerprint on the hand. If you still Worried about that the direct paste is not strong enough, you can use a lighter or a hair dryer to heat the rubber surface to make it stronger.
️ After sticking, press by hand for 1 minute to let the air out.(The ideal temperature for pasting is 15-38 ° C, not lower than 10 ° C)

NOTE: IF YOU ARE NOT SATISFIED WITH OUR PRODUCT, PLEASE CONTACT WITH US OFFLINE, WE WILL SOLVE FOR YOU PROFESSIONALLY. PLEASE DON NOT LEAVE BAD COMMENTS, THANK FOR YOUR HELP.

#CarStickers #5D #Carbon #Fiber #Rubber #Styling #Car #Door #Sill
#KIA #Toyota #BMW #Audi #Mazda #Ford #Hyundai #MG #Proton
Giá FEED